CB-100_e.book 6 Z8 ??????e??xý
Å
Uxý9 V??p??Â
Panel Descriptions
13. EFX (Effects) Knob15. RECORDING OUT/PHONES Jack
Turn this knob to chorus, flanger, or T-wah to select the When Using RECORDING OUT
corresponding effect. Turn the knob to adjust the amount of Connect to a recorder or other recording device.
effect applied.Features COSM speaker modeling, allowing you to use the
The ON indicator lights up when EFX is turned on, and goes CUBE as a high-performance amp simulator.
out when EFX is turned off. You can also turn EFX on and off When Using PHONES
using an optional foot switch (the BOSS FS-5U).
Connect headphones to this jack.
* Graduations for CHORUS, FLANGER and T-WAH on a panel are The COSM speaker modeling allows the bass amp to produce
for reference. Be sure to check the sound as you adjust the effects.sounds with real punch.
fig.02
* No sound is output from the CUBEOs speaker or any external speaker
CHORUSwhen the RECORDING OUT/PHONES jack is in use.
In this effect, a slightly detuned sound is
* As a feature designed to protect the unit's circuitry, sound is
added to the original sound, giving the prevented from being output from the speakers for a few moments
sound greater breadth and fullness.whenever a plug is disconnected from the RECORDING OUT/
Turning the knob to the right increases
the rate and deepens the chorus effect.PHONES jack. This does not indicate the unit is damaged.
fig.0316. POWER Switch
FLANGERTurns the power on and off.
This creates a flanging effect that creates
* This unit is equipped with a protection circuit. A brief interval (a few
a sort of spinning sensation with the seconds) after power up is required before the unit will operate
sound.
Turning the knob to the right increases normally.
the rate and deepens the flanging effect.* Always make sure to have the volume level turned down before
switching on power. Even with the volume all the way down, you may
fig.04
still hear some sound when the power is switched on, but this is
T-WAHnormal, and does not indicate a malfunction.
The frequency response of the filter
changes according to the input level, 17. Power Indicator
producing unique changes in the timbre.This indicator lights when the unit is turned on.
Turning the knob to the right increases
the sensitivity to the input level.
Adjust this to obtain the optimal effect,
which is matched with the output level
of your bass.
14. DELAY/REVERB Knob
Turn this knob to DELAY or REVERB to switch to that effect.
Turn the knob to adjust the amount of effect applied.
* Graduations for DELAY, REVERB on a panel are for reference.
Be sure to check the sound as you adjust the effects.
fig.05a
DELAY
Turn the knob to change the delay time.
fig.05b
REVERB
Turn the knob to adjust the reverb level.
6 |