104118
Y Try to prevent cords and cables from Y Should you remove wing nut, washers, or
becoming entangled. Also, all cords and stopper bolt, make sure to put them in a safe
cables should be placed so they are out of the place out of children's reach, so there is no
reach of children.chance of them being swallowed accidentally.
................................................................................................................................................................................................
106
Y Never climb on top of, nor place heavy
objects on the unit.
................................................................................................
IMPORTANT NOTES
291a
In addition to the items listed under OUSING THE UNIT SAFELY� on page 3�4, please read and observe the
following:
PlacementAdditional Precautions
354b553
Y Do not expose the unit to direct sunlight, place it Y Use a reasonable amount of care when using its
near devices that radiate heat, leave it inside an jacks and connectors. Rough handling can lead to
enclosed vehicle, or otherwise subject it to temper-malfunctions.
ature extremes. Also, do not allow lighting devices 556
Y When connecting / disconnecting all cables, grasp
that normally are used while their light source is
the connector itselfNnever pull on the cable. This
very close to the unit (such as a piano light), or
powerful spotlights to shine upon the same area of way you will avoid causing shorts, or damage to
the cableOs internal elements.
the unit for extended periods of time. Excessive
558d
heat can deform or discolor the unit.Y This instrument is designed to minimize the extra-
355
Y To avoid possible breakdown, do not use the unit in neous sounds produced when itOs played. However,
a wet area, such as an area exposed to rain or other since sound vibrations can be transmitted through
floors and walls to a greater degree than expected,
moisture.
356take care not to allow these sounds to become a
Y Do not allow rubber, vinyl, or similar materials to nuisance to neighbors, especially when performing
remain on the unit for long periods of time. Such at night and when using headphones.
objects can discolor or otherwise harmfully affect 559a
Y When you need to transport the unit, package it in
the finish.
357the box (including padding) that it came in, if
Y Do not put anything that contains water (e.g., possible. Otherwise, you will need to use equivalent
flower vases) on the unit. Also, avoid the use of packaging materials.
insecticides, perfumes, alcohol, nail polish, spray 562
Y Use a provided cable or a cable from Roland to make
cans, etc., near the unit. Swiftly wipe away any
the connection. If using some other make of
liquid that spills on the unit using a dry, soft cloth.connection cable, please note the following precau-
tions.
MaintenanceY Some connection cables contain resistors. Do not
401ause cables that incorporate resistors for
Y For everyday cleaning wipe the unit with a soft, dry
connecting to this unit. The use of such cables can
cloth or one that has been slightly dampened with cause the sound level to be extremely low, or
water. To remove stubborn dirt, use a cloth impreg-impossible to hear. For information on cable
nated with a mild, non-abrasive detergent. After-
specifications, contact the manufacturer of the
wards, be sure to wipe the unit thoroughly with a
cable.
soft, dry cloth.
402
Y Never use benzine, thinners, alcohol or solvents of
any kind, to avoid the possibility of discoloration
and/or deformation.
4 |
ACEC
